Made this little bezel for around the doorbell camera. I think it dresses it up a little.
12 Likes
it looks like it’s worth $1000 
1 Like
Not at all a bad addition there…certainly dresses things up a bit. It’s interesting to see that you’ve done this, as I hadn’t really considered the potential advantage of doing so myself until seeing your post.
My eufy 2K wired doorbell cam really could benefit (better line of sight & overall viewing perspective) from being moved to the OPPOSITE side of my front door jam despite that being the hinge side of the door, but alas, I didn’t want to rip out the door trim / casing for extended bell wiring for marginal gains.
I initially tried using the included shim which I believe is 15™ and it was way too much angle for my application so it’s simply flush mounted.
You’ve given me an idea for how to dial in the best angle with fairly minimal investment of time materials, etc.
How did you go about fabricating yours??
Seems like a super easy job for a quality 3D printer!
2 Likes
Thanks!!
maybe I should open an Etsy shop haha 
1 Like
I wish I did have a 3D printer, I could have really made something fancy.
I used a scrap piece of expanded foam pvc (pvc board) mitered the edges to a 45 and routed out the center to fit the mounting bracket.
The brick on my house is so rough, the camera looked really ugly mounted to it so I tried to dress it up a little bit.
