Hi guys
I got an Eufy system with 4 Eufycam2 cameras. I have a camera that regularly disappears from the homebase configuration. I have to re enter its config and then it runs OK during a couple of days. Then it disappears again.
Any clue on this issue? Firmware version is the latest one from December 2020.
Thx
How far is it from your homebase? It may not have enough signal. If you go into the camera menu, under mounting, there is a signal test section. What does that show?
One test you can try is swap cameras and see if other cams have the same problem in that location. If that’s the case, its probably signal. If the original camera has that problem in more than 1 location, you probably have a defective camera.
1 Like