How can I define a username and password for RTSP?
Hi guys,
I have followed the entire SOP to setup my EufyCam E and indoor Cam. However, I encountered an issue that cams can be connected with no issue but only last for around 2-3 minsā¦, then it disconnected on the Surveillance Station. I used VLC try to stream to the IP Cam and it can be also streamed, but againā¦ it disconnected in about 2-3 mins and both SS and VLC wonāt reconnect it back again.
Does anyone have the same issue like me? Really want to solve this issueā¦, thank you.
Its that way by design. The cams arenāt active all the time so you lose the stream when they turn off. The cam E is a battery cam and would go through the battery in less than a week if the stream was active all the time. You may be able to stream the indoor cam continuously if you set it to record continuously, but it wonāt if its set up for motion detection.
You should be able to save clips to your NAS if you set things up correctly. In the setup there is an instruction to trigger the cam when setting up the RTSP feed so that the NAS can capture the feed and save the stream address. If you donāt get that right, it will act exactly like you are seeing and not reconnect when the camera wakes up. I think the Help section of the app explains this, but its been so long since I set one up, I donāt remember the exact sequence.
Thank you Pysailr,
For both Cam E and indoor cam, they have the same issues like my mentioned. and I do think like you said there are some points that I did incorrectly. Can you direct me where I can find the trouble shooting? The Help section of the app does not help me to solve the issue.
1 Like
Try this link. http://community.anker.com/t/how-to-setup-rtsp-on-eufycam-to-stream-video-to-your-compatible-nas/64833
1 Like
Hello Yanyee1, is this solved or do you have a timeline for this ?
Kind Regards
Hi, Yanyee1,I just found this thread after installing my Eufy wired doorbell. I have a Synology NAS. I was disappointed to read that the doorbell camera does not support RTSP. Is there any news on when this might become available? Are there any workarounds??
I canāt get this to work properly. My NAS is only receiving 1080p for my 2k camera. How do I get my NAS to receive 2k?
2 Likes
I have the same problem as euf66, playing and recording only in 1080p, no 2k (on Nas Synology DS220 +).
Moreover, I do not have access to pan & tilt on my Nas.
Thank you for your reply.
Please support the wired doorbell with RTSP/NAS.
1 Like
I have the same NAS and cannot find any settings to enable recoding of cameras. Very limited device Iām finding now.
I still have no idea what purpose this serves. I use an imac. Homebase 2 and only Eufy gear.
Can you record continously 24/7 to the nas?
Hello I have western digital EX41000 NAS how can I add my camera to WD?
Ditto, please add support for the wired doorbell with RTSP/NAS. Thank You:)
1 Like
Hi not a NAS but need similar advice to add a camera to a security system. Can anyone advise me as to what needs to be put into the following connection page on a security system app? My camera is the E220 Indoor cam (T8410) which is an IP camera. I need an image command, the Cameraās HTTP command to recieve a snapshot image.i.e./ cgi-bin/snapshot.cgi . Is this even possible with a Eufy E220 Indoor cam? People generally use HIK vision units with the system but I would love to use this Eufy. Please picture attached of the fields I need to fill. Any advice would be appreciated.
